Thank you for this post. I am about three years into wood working with handtools. I didn’t want to be a handtool collector. I wanted a good set of tools I could use. Since funds were tight and I wasn’t sure if I would keep doing this, I wanted to build my tools slowly. What you outlined is more or less what I ended up getting and it has indeed served me well. One can easily do a lot with all of these tools. At some point about two years into the hobby, I had a much better feel for what I wanted to make and what I may or may not need beyond this.
All reps were extremely helpful throughout the process of figuring out what to order. When problems developed due to mistakes by my installer not connected to Woodworker Express, the reps sent replacement hinges without charge. Jason, particularly went the extra mile and more helping me figure out what the problems were and how to solve them, even though the problems were not related to or caused by Woodworker Express..
A marking knife is used for marking where you will be cutting with your saws and chisels. For getting into tight spots (like dovetails) and making very accurate lines (which is vital for tight fitting joints) you need just the right marking knife. You would think that any old knife would work, but you would be wrong. Years ago I purchased several that didn’t work well. 

about three years ago I thought to make even only a cutting board I would need a complete set of machines, stationary and handmachines, plus of course a few handtools for “hybrid woodworking”, then I discovered Peter Sellers and most importantly Chris and The Anarchist’s Tool Chest, that was a revelation! So I find it absolutely awesome that you show us how to start with even less tools (especially the advice for saws is great, much cheaper to only get rip)!

Whilst I agree with everything you say there has to be a but 😀 and here it comes, after promising myself I’d have the bench of my dreams since my apprenticeship 42 years ago I finally two years ago built a three quarter ton steamed beech monster with all the bells and whistles. If only I’d had it years ago to me it’s the most important tool in my workshop now ! Solid, heavy, side and head vice, dog holes everywhere, sliding deadman the lot and yes very very pretty. But built to be used as a bench and with some visiting clients a showpiece! But more than anything because I could
I have to say, reading your blog and watching your videos makes me want to get started immediately on traditional woodworking. The problem I have is that hand tools are hard to come by at swap meets or antique stores out here in Bakersfield, CA. I have made several trips and so far all I have found is a beat-up old Jack plane. I would rather buy used, but I am a little leery of EBay, so my options are limited. Thank you for your posts on what to buy and links to websites. I haven’t bought anything yet, but… Read more »
I just found you site and from what I have seen so far is very impressive. I cannot believe it took me this long to find it. I have a question concerning the Stanley 62 folding rule that you and Chris Schwarz recommend. I checked on ebay and there seems to be a wide range in prices. Do you have any more information or a recommendation as to the where more research could be done on these rules? Also, if I win the video, I would like the Howarth Bow Saw video and/or the black Got Wood? t-shirt. I live… Read more »
×