All reps were extremely helpful throughout the process of figuring out what to order. When problems developed due to mistakes by my installer not connected to Woodworker Express, the reps sent replacement hinges without charge. Jason, particularly went the extra mile and more helping me figure out what the problems were and how to solve them, even though the problems were not related to or caused by Woodworker Express..
now I finally know what to recommend my friends when I try to convince them to give handtools a try (I currently am doing an apprenticeship in cabinetmaking (unfortunately mostly particle board) and said friends they do the same and often have no clue what can be achieved with handtools alone) because up until now, I never knew what to recommend for sharpening as my setup is great but very expensive. And I guess if I recommend to get two stones instead of a combination stone, one can keep one side flat for flattening the backs of new chisels, and add a strop with some polishing compound I really can’t think of anything else one would need for a long time! 

While some people consider the circular saw to be more of a carpentry tool than a fine woodworking tool, but some would disagree. There may be no more versatile basic handheld power tool than a circular saw. When used with a clamp-on straight-edge, the circular saw can be just about as accurate as a table saw and handle quite a few of the tasks that one would attempt with a table saw, particularly cutting sheet goods such as plywood or medium-density fiberboard. When woodworking on a budget, a quality circular saw should be the first handheld power tool purchased, as it is the one that will likely be the most useful as you get started.

Handsaws (often called “panel saws”) are long, thin saws with a comfortable wooden handle. They are used for rough dimensioning of your lumber. Although a “panel saw” is technically a smaller handsaw that fits into the panel of a tool chest, I’ll hereafter refer to this type of saw as a “Panel Saw” to differentiate them from the broad category referred to as “hand saws”. Panel saws come in two tooth configurations: “Rip” (cuts along the grain…like a chisel) and “Cross Cut” (cuts across the grain…like a knife). You will need both.
For a huge and amazingly useful website with hundreds of quick tips and tricks for woodworking, visit woodworking tips to find some of the most useful things that will assist you with all things woodworking. If you have a question or need a tip on getting something done concerning your woodworking project, the woodworking tips website will be a great resource.
Love this article and the videos, very informative. As a beginning woodworker I have chosen on the traditional means because I can find some good deals at local flea markets and with a little tune up the tools work good. This video give great tips for the new woodworker and the basic essentials needed for getting started. One area I need help is in clamping so I would be honored to win a set of the clamps. If I am not picked for the clamps, an XL shirt would fit (disston seal), my choice of video would be “Building the… Read more »
Block planes have become one of the most oft-used tools in a woodworker’s workshop. Some traditional woodworkers even keep them in their aprons! These little planes can be used to trim your joints, put chamfers on board edges, trim end grain, etc. I would recommend finding a low angle block plane, because the low angle lets you cut difficult grain more easily. My handplane buying guide goes into more detail about the features and brands that you should look for when purchasing a good quality block plane.

“Basic,” on the other hand, is a word that allows for growth – and that’s exactly what you want in your woodworking tool kit. You want to be able to take the same kit with you through many years in the craft. With my basic woodworking tools list, I wanted to provide a core set of tools that will serve you well from project to project. I’m especially concerned these days with the transition to hardwood furniture making, as opposed to plywood boxes of various sizes. That’s the transition I’m making right now in my own work!

×