The block height’s going to be a personal thing, depending on what you use it for. Mine’s about knee height, which is on the low end, but I did use to do a tremendous amount of prepping straight from the tree. As you’re the same height as me, I’d say 33″ would be a tad on the high side. If you imagine you’ve got a longish piece of wood to work down the length, you want to be holding it almost vertical, rather than angled as it’s less likely to slip. The higher the working surface, the more angled it’s naturally going to become, hence why mine’s so low.
Having very sharp tools is one of the most important aspects of proper traditional woodworking with hand tools. Many beginners think that they stink at woodworking, but usually they are just using dull (or improperly sharpened) hand tools. To start off with I recommend buying quality sharpening supplies for sharpening & honing your chisels, hand plane irons, and handsaws. And I’ll help you save money by avoiding systems that don’t work as well.
To start off you only need either a 1/4-inch or 3/8-inch mortise chisel (or some size close to those). I prefer 3/8-inch. You don’t need a whole set of mortise chisels. Mortise chisels (also spelled “mortice chisels”) are used for chopping mortises (rectangular holes) into the side of your board to accept the insertion of a tenon. “Mortise and Tenon” is a very common and very strong joint that most people have heard of.
But before you purchase clamps, build your first project and put it together without glue. Then see how many clamps you think you will need to put enough pressure in all the right spots. Then proceed to purchase that number of clamps. Repeat this process on your next project, and purchase more clamps if needed. This is better than running out and buying a huge collection of woodworking clamps. See my buying guide for different clamp types, uses, and my favorite brands.
I consider this my “basic” tool list. Although I do not have a dedicated box for these tools, I assure you that they have a great home in cabinets, on shelves, and laying around on benches. When I do need to take my hand tools somewhere, the larger tools end up in a simple tongue and grooved latch box my grandfather owned. The smaller tools are always in my overall pockets. Overalls work great. They have multiple pockets, they’re comfortable, and they protect your upper body and legs. You only have to deal with small chunks of wood getting into the pockets, which can be dealt with if you or your other half are crafty enough to sew some flaps. It doesn’t bother me though. Thanks for your time.
Dividers (or compass) are used for taking and repeating a measurement over and over again on a work piece. Traditional woodworkers rarely take measurements with a tape measure when doing fine joinery work, but rather take a measurement with dividers then transfer that arbitrary (yet accurate) measurement to another work piece. This removes a degree of inaccuracy.
Dan, I’m worried about you. The stress must be getting to you. Somehow you’ve lost your ability to count. By my estimation, your list has at least 29 items, some of which are actually “sets” of items, like chisels or crayons, which I only counted as one item. Perhaps you need a break from all that blogging, and time to get back to basics, like counting. I can help. Come over to my shop and we can count things like parts, items on the honey-do list, and for extra credit, screw holes. Don’t worry about making mistakes, I’ll guide you through it, and we can round up if necessary. Ha!
I just found you site and from what I have seen so far is very impressive. I cannot believe it took me this long to find it. I have a question concerning the Stanley 62 folding rule that you and Chris Schwarz recommend. I checked on ebay and there seems to be a wide range in prices. Do you have any more information or a recommendation as to the where more research could be done on these rules? Also, if I win the video, I would like the Howarth Bow Saw video and/or the black Got Wood? t-shirt. I live… Read more »